BODY GUARD

Bedliner Hard protective structure

High-grade, two-part polyurethane enamel designed for areas where a tough coating is required, offering a distinct structural finish. Suitable for refined, semi-transparent painting processes, it boasts resilience against scratches and abrasion. Initially developed as a premium enamel for pickup truck cargo spaces, it is widely adopted as a 'custom finish' across various vehicle types, prioritizing both aesthetic appeal and scratch resistance. Its rapid curing, exceptional scratch resistance, and robust chemical resilience distinguish it in application.

Available colors:

Product benefits: Durable Hard protective structure Roller application Spray gun application UV Resistance
Packaging (liters): 0.71, 0.711, 0.71

more information on this product

Specification

Application

Specification

DURABLE

HARD PROTECTIVE STRUCTURE

SPRAY GUN APPLICATION

ROLLER APPLICATION

UV RESISTANCE

APPLICATION

- pickup, truck beds
- bus floors
- bumpers
- frames
- off-road vehicles
- construction machinery

SPRAY VISCOSITY

25-30 sec. DIN Flow Cup 4mm

PAINT EFFICIENCY

2 m2/l (without thinner, thick coat)
max 10 m2/l (depends on amount
of thinner)

POT LIFE

1 hrs

DRY FILM THICKNESS

Highly dependent on way
application

MINIMUM SHELF LIFE

Body Guard: 24 months in originally
sealed packaging
Body Guard Hardener: 12 months
in originally sealed packaging

VOC

2004/42/WE/IIB(e)(840)<840

Application

SUBSTRATE PREPARATION

For existing paint layers: Begin by degreasing
using siliconee remover CP 015, followed by
sanding with 240-320 abrasive paper, and
another round of degreasing
For acrylic or epoxy primers: Start with
degreasing using silicone remover CP 015,
proceed with sanding using 240-320 abrasive
paper, and then degrease once more. When
utilizing the CP 394 epoxy primer, it permits
the application of Body Guard coating without
sanding for up to 12 hours post-epoxy primer
application
IMPORTANT: Apply on epoxy primer with an
approximate 1-hour evaporation time at 20°C
Steel, galvanized steel, aluminum, stainless
steel: Sand with 240-320 abrasive paper and
coat with epoxy primer CP 394
Polyester laminates: Degrease using silicone
remover CP 015, sand using 240-280 abrasive
paper, and repeat the degreasing process

MIXING RATIO

BLACK
Body Guard - 711ml
Body Guard Hardener - 237ml
Acrylic thinner CP 040/ CP 070/ CP 075 - 0-40%
Blend the product with the hardener at a volume
ratio of 3:1 and ensure thorough mixing. For the
prepared mixture, the product can be diluted by
a maximum of 40% (using acrylic thinner),
depending on the application method

TRANSPARENT
Body Guard - 711m mix with
+ 7-10% (50-75g) ACRYL/LV CRYL/Simplex
Body Guard Hardener - 237ml
Acrylic thinner CP 040/ CP 070/ CP 075 - 0-40%
Fill the bottle with your chosen colourant (acrylic
(ACRYL/LV CRYL) or Simplex pigment), aiming for
7-10% (50-75 g). Seal and shake the bottle well until
the colour is consistent. Add the hardener (3:1 volume
ratio) to the already coloured Body Guard. Seal and
thoroughly mix for about 2 minutes. For application
flexibility, you can dilute the prepared mixture by up
to 40% using acrylic thinner